- YAC server to NCID server gateway
acts as a YAC client, listens to the CID information from a YAC
server and sends it to the NCID server. The server then sends the CID
information to the NCID clients.
It is important to understand that to run YAC server with NCID clients you must
run YAC2NCID gateway as well as NCID server.
The configuration file for yac2ncid
. It may be located in same directory
as the script, or in the etc
directory, or in NCID default
configuration directory. Read the comments in the config file for more
can run on any system, but normally it is run on same box as the
NCID server. If it is not run on the same box as the NCID server, you must
configure the server IP address in the configuration file.
Configure the YAC server with IP address of the box running YAC2NCID
relies on netcat binary (nc). As there are multiple
implementations of this binary in existence, the script will try to auto
detect the options to use. If script is unable to properly detect the version
of nc, set NETCAT_TYPE to CUSTOM in the config file and set custom parameters
to match your version.
There is also a client output module called ncid-yac
. It sends the NCID
CID information to YAC clients.
- -p <PIDFILE>
- Sets the PID file name.
- Verbose mode.
- Display version.
ncid2ncid.1, yac2ncid.1, ncid.1, ncidrotate.1, ncidtools.1 yac2ncid.conf.5,
ncidtools.7, ncidd.8, sip2ncid.8