NAME

VERSION

USAGE

OTHER DOCUMENTATION

man 1 policyd-spf provides general operation documentation for this package.

See man 5 policyd-spf.conf for configuration file information.

SYNOPSIS

Additionally, different configurations can be provided on a per user basis. This man page describes setup and user of per user (mail recipient) configurations. Currently these configurations can only be stored in a text file. If there is sufficient interest, other data storage methods may be supported in the future.

DESCRIPTION

Most options available at the application level (See man 5 policyd-spf.conf) can be adjusted on a per-user basis. Per-user checks can only be done as part of smtpd_recipient_restrictions. Per-user actions are not possible at other stages of the SMTP dialogue. The user is not yet known for smtpd_client_restrictions, smtpd_helo_restrictions, or smtpd_sender_restrictions. If used during smtpd_data_restrictions or smtpd_end_of_data_restrictions, the entire message will be available only if the message was only to a single recipient. If per-user configurations are used when recipient information is not available, warnings will be logged and the per-user information will be ignored.

The following options cannot be modified on a per user basis: Lookup_Time, Header_Type, Hide_Receiver, Authserv_Id, Prospective, debugLevel, and Mock.

In addition to specifying individual users, regular expression matching is also available, but may have performance implications since the entire user table has to be traversed for each message recipient.

OPTIONS

Text Per-User Configuration File

"Per_User = text,/usr/local/etc/pypolicyd-spf/userconf"

Lines beginning with "#" are treated as comments and ignored. The location of the file is determined by the system administrator. No default file is provided in or installed by the package.

The configuration of the file is a comma separated combination of user and configuration information, with one line per user's configuration information (NOTE: due to man page formatting requirements, these lines may be wrapped in your pager - in the config file, it must be one line per user):

postmaster@example.com,Mail_From_reject=No_Check|PermError_reject=False|HELO_reject=SPF_Not_Pass|TestOnly=1|debugLevel=5|skip_addresses=127.0.0.0/8,::ffff:127.0.0.0//104,::1//128|TempError_Defer=False strict@example.com,PermError_reject=True|HELO_reject=SPF_Not_Pass|TempError_Defer=True

It is not necessary to specify all configuration parameters for each user, only those that are different than the overall configuration need to be specified.

If the specified per user configuration file is missing, an error is logged and the global configuration is used instead.

SEE ALSO

AUTHORS

This man-page was created by Scott Kitterman <scott@kitterman.com> and is licensed under the same terms as the program.