|
NAMEifdata - get network interface info without parsing ifconfig outputSYNOPSISifdata [options] {iface} DESCRIPTIONifdata can be used to check for the existence of a network interface, or to get information about the interface, such as its IP address. Unlike ifconfig or ip, ifdata has simple to parse output that is designed to be easily used by a shell script.OPTIONS-hPrint out a help summary.
-e Test to see if the interface exists, exit nonzero if it
does not.
-p Prints out the whole configuration of the
interface.
-pe Prints "yes" or "no" if the interface
exists or not.
-pa Prints the IPv4 address of the interface.
-pn Prints the netmask of the interface.
-pN Prints the network address of the interface.
-pb Prints the broadcast address of the interface.
-pm Prints the MTU of the interface.
Following options are Linux only. -ph Prints the hardware address of the interface. Exit with a
failure exit code if there is not hardware address for the given network
interface.
-pf Prints the flags of the interface.
-si Prints out all the input statistics of the
interface.
-sip Prints the number of input packets.
-sib Prints the number of input bytes.
-sie Prints the number of input errors.
-sid Prints the number of dropped input packets.
-sif Prints the number of input fifo overruns.
-sic Print the number of compressed input packets.
-sim Prints the number of input multicast packets.
-so Prints out all the output statistics of the
interface.
-sop Prints the number of output packets.
-sob Prints the number of output bytes.
-soe Prints the number of output errors.
-sod Prints the number of dropped output packets.
-sof Prints the number of output fifo overruns.
-sox Print the number of output collisions.
-soc Prints the number of output carrier losses.
-som Prints the number of output multicast packets.
-bips Prints the number of bytes of incoming traffic measured
in one second.
-bops Prints the number of bytes of outgoing traffic measured
in one second.
AUTHORBenjamin BAYART
Visit the GSP FreeBSD Man Page Interface. |