Which platforms does Device::USB support?

There is a port of the "libusb" library to the Windows environment called "LibUsb-Win32". Because I don't have a development environment for testing this library, "Device::USB" does not yet support this library.

Do I have to use Device::USB as root?

Using the "Device::USB" module as root avoids this feature, but is not very satisfying from a security standpoint. (See the next question for more options.)

How do I enable use of Device::USB as a non-root user?

1)

/dev/bus/usb - pre-2.6.11: via devfs / post-2.6.11: via udev

2)

/proc/bus/usb - usbfs

Look in both locations on your system for which of these two methods your libusb will use.

No matter which method your system uses, you will probably want to create a separate group to control access. Run this command to add a system group:

  addgroup --system usb

or

  groupadd --system usb

You can then add users to that group to allow access to your usb devices.

DEVFS / HOTPLUG

TODO

UDEV

If you use Debian/Ubuntu, look in the /etc/udev/permissions.rules file. If you want to allow global access to all usb devices, make this change:

Change this: SUBSYSTEM=="usb_device", MODE="0664"

To this: SUBSYSTEM=="usb_device", MODE="0664", GROUP="usb"

After you reboot, all usb devices will inherit the mode and group specified.

If you want to only change permissions for certain devices, you can add this on one line and adjust the product and vendor IDs:

  SUBSYSTEM=="usb_device", GROUP="usb", \
    SYSFS{idVendor}=="1234", SYSFS{idProduct}=="1234"

USBFS

The usbfs defaults to root as the user and group. This can be changed in the /etc/fstab by adding the following on one line:

  none /proc/bus/usb usbfs noauto,\
      listuid=0,listgid=118,listmode=0664,\
      busuid=0,busgid=118,busmode=0775,\
      devuid=0,devgid=118,devmode=0664\
      0 0

The value 118 in the above should be replaced with the group id of your usb group (created above). The list* values are to allow listing devices, the bus* is to control access to the bus directories and the dev* values control access to the device files. This approach does not allow the kind of granular permission that the udev approach gives, so it is all or nothing unless permissions are changed programmatically.

If your /etc/fstab file already has a line for /proc/bus/usb, add the options above to the line that is already there rather than adding the new line. For example, you would change

  usbfs   /proc/bus/usb   usbfs   noauto  0 0

to

  usbfs   /proc/bus/usb   usbfs  noauto,\
      listuid=0,listgid=118,listmode=0664,\
      busuid=0,busgid=118,busmode=0775,\
      devuid=0,devgid=118,devmode=0664\
      0 0

Once again, this needs to be all on one line with the "\" characters removed.