|
NAMEixgbe —
Intel(R) 10Gb Ethernet driver for the FreeBSD operating
system
SYNOPSISTo compile this driver into the kernel, place the following lines in your kernel configuration file:device iflib
device ixgbe Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): if_ixgbe_load="YES" DESCRIPTIONTheixgbe driver provides support for PCI 10Gb Ethernet
adapters based on the Intel 82598EB Intel(R) Network Connections. The driver
supports Jumbo Frames, MSIX, TSO, and RSS.
For questions related to hardware requirements, refer to the documentation supplied with your Intel 10GbE adapter. All hardware requirements listed apply to use with FreeBSD. Support for Jumbo Frames is provided via the interface MTU setting. Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility configures the adapter to receive and transmit Jumbo Frames. The maximum MTU size for Jumbo Frames is 16114. This driver version supports VLANs. For information on enabling VLANs, see ifconfig(8). HARDWARETheixgbe driver supports the following cards:
DIAGNOSTICS
SUPPORTFor general information and support, go to the Intel support website at: http://support.intel.com.If an issue is identified with the released source code on the supported kernel with a supported adapter, email the specific information related to the issue to <freebsd@intel.com>. SEE ALSOaltq(4), arp(4), iflib(4), netintro(4), ng_ether(4), polling(4), vlan(4), ifconfig(8)HISTORYTheixgbe device driver first appeared in
FreeBSD 7.0.
AUTHORSTheixgbe driver was written by Intel
Corporation
<freebsd@intel.com>.
Visit the GSP FreeBSD Man Page Interface. |